• <xmp id="o0okk"><table id="o0okk"></table>
    <xmp id="o0okk">
  • <td id="o0okk"><table id="o0okk"></table></td>
  • <bdo id="o0okk"><center id="o0okk"></center></bdo>
  • <menu id="o0okk"><center id="o0okk"></center></menu>
  • Service Hotline

    +86-13389958678

    Lattice Girder Welding Lines YFE350-18


    Brief introduction

    It adopts five 5mm-12mm rebar of cold rolling ribbed or hot rolling round bar.The production process is steel bar be dragged from raw material device,straightening,bending,welding,forming,cutting and collecting,the end product will be triangle lattice girder.It is mainly used to rebar construction making of high speed railway and truss lattice floor deck.The whole product line can be operated by one people,the fast production speed will be 18m per minutes.

                                                                   

         Technical parameter

    No.ItemUnitQuantity
    1The weight of the laying linekg/coil
    2000
    2The number of laying linePcs5
    3Longitudinal wire diameter(upper and lower)mm5-12
    4Diagonal wire diametermm4-7
    5Step/Strokemm190-210
    6Girder heightmm70-350
    7Girder width mm70-110
    8Girder lengthm2-14
    9Produce ratem/min
    18
    10Pulling typemmHydraulic clamp traction



    日日摸夜夜添夜夜添无,不收费的附近约会软件,邻居老师婬荡乱婬小说
  • <xmp id="o0okk"><table id="o0okk"></table>
    <xmp id="o0okk">
  • <td id="o0okk"><table id="o0okk"></table></td>
  • <bdo id="o0okk"><center id="o0okk"></center></bdo>
  • <menu id="o0okk"><center id="o0okk"></center></menu>